I have a Linksys USB200M ver 2.1 and it will not work on Ubuntu. The device is recognized and handled by usbnet. A network interface is created, but no traffic is successfully transmitted. Previous versions of this device worked well with usbnet.

This product is not properly working on my machine. I can see messages when it is plugged in. Device (eth) is created and the device can be pinged.

I cannot make it work to send data or ping outside of the box.

works out of the box with 2.6.22, ethernet interface created immediately, no problem

Works fully under Slax 5, not at all under Puppy 2, as they are both outdated comments on Puppy might not be true anymore. USB200M VER2

I'm using Ubuntu 8.04 kernel 2.6.24-18-generic.

Everything works by just pluging it in:

4151.076069 eth1: register 'asix' at usb-0000:00:1d.7-5, ASIX AX88772 USB 2.0 Ethernet, 00:1d:7e:01:37:44
4151.076112 usbcore: registered new interface driver asix
4151.283277 eth1: link down
4151.289148 ADDRCONF(NETDEV_UP): eth1: link is not ready
4156.540327 tg3: eth0: Link is down.
4160.739038 ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
4160.742292 eth1: link up, 100Mbps, full-duplex, lpa 0xC5E1
4168.385975 usb 4-5: USB disconnect, address 5
4168.386591 eth1: unregister 'asix' usb-0000:00:1d.7-5, ASIX AX88772 USB 2.0 Ethernet

detected and set OK right away after plugin
then ifup got it an IP@ using DHCP
debian sarge 2.4.27 updated to etch and still running